Show Posts
1
Pumps, Wells, Tanks, Controls / WELL SEDIMENT
« on: June 01, 2013, 04:52:07 AM »
I have fairly heavy sediment from my well and while it is controlled by a sediment filter system after the pressure tank, I am concerned about the check valve, pressure switch and possible sediment buildup in the pressure tank.
If one were to place a sediment filter before the check valve (and I know this is considered a no-no) and if one was to install either your EPS15/99 and/or CYCLE SENSOR, would either feature shut off the pump if the filter became plugged to prevent pump burnout (desire manual purge over a automatic purge)?
Wondering in W(BY GOD) V....
And yes, I do have your CSV...
If one were to place a sediment filter before the check valve (and I know this is considered a no-no) and if one was to install either your EPS15/99 and/or CYCLE SENSOR, would either feature shut off the pump if the filter became plugged to prevent pump burnout (desire manual purge over a automatic purge)?
Wondering in W(BY GOD) V....
And yes, I do have your CSV...