Show Posts
1
Irrigation / Wanting to use a CSV for an Irrigation Pump
« on: April 11, 2018, 06:23:02 AM »
So I pull irrigation water off of a canal near my house, which gives about 12-15 psi suction pressure to a 2 HP irrigation pump. I have an automatic sprinkler system I’m setting up with 5 stations. The estimated flow that we went with for the design is going to be 45 gpm at 50 psi per station. I will only be running one station at a time, so I’ll have timers set up where one station shuts off and the next one opens directly after hopefully this will still allow the pump to stay running between stations. I have a little 5 gallon pressure tank and a 40 - 60 pressure switch, my question is which CSV should I go with ? Thanks for any help!