1
Pumps, Wells, Tanks, Controls / PK1A Setup
« on: November 08, 2021, 12:29:09 PM »
I ordered a PK1A kit and it arrived about a half hour ago. I saw a video on youtube on installation of the PK125. It said that the 125 was designed to fit inside the well casing. Is this also the case with the PK1A? I am very much a novice to anything plumbing, mechanical, or electrical (unfortunately) and was hoping I could take the PK1A out of the box and put it EXACTLY where the existing tank (along with the switch, gauge, etc) were. Please see attached pic.
Is this do-able or is there more to installing this than that? Thanks much for any advice.
Joe
Is this do-able or is there more to installing this than that? Thanks much for any advice.
Joe