Author Topic: New well, new pump, what do you suggest?  (Read 141 times)

Zoomschwortz

  • Newbie
  • *
  • Posts: 24
    • View Profile
New well, new pump, what do you suggest?
« on: November 11, 2026, 09:52:56 AM »
New well is in, new pump installed and now waiting for lab water report.
Time to decide which Cycle Stop and?

The Well

6" steel casing, 105' deep and drilled 2' deeper for total of 107' deep.

Franklin 25FA1554-3W230 set at 100'

Static 56'
Drawdown 27 gpm shy of 59' driller rounded to 59', at well head, no tank, throttled back to 27 gpm.  with 70 psi S/B 23 gpm and less drawdown

Down Pipe 1 1/4" schedule 120
1 1/4" Pitless

Horizontal 1 1/4", 200 psi black poly 100' to tank/filter/C/S house.

Inside filter house I want to continue with 1 1/4" ID pipe unless no way to get around it.

Which Cycle Stop for 60psi and do you have ready made kit with 1 1/4" fittings?

Currently unknown if I will need iron and/or Water Softener, but do you know of good quality, self installed rated for up to 25 gpm but will also work with lower volume 3-5 gpm use? I want to do some research to be prepared.

Thank you
Ken
« Last Edit: November 11, 2026, 08:20:27 PM by Zoomschwortz »

Zoomschwortz

  • Newbie
  • *
  • Posts: 24
    • View Profile
Re: New well, new pump, what do you suggest?
« Reply #1 on: Today at 09:33:03 AM »
I'm still waiting for Lab Results for the Health Department.

Well driller did his tests and I have his results.

Water clarity per Health Department must be 10.0 or lower. Actual results 0.4

Hardness      6 GPG

Iron             0 PPM

PH               7.5

Manganese  .6

TDS            113 PPM

Visible Particles = Sand

Well Driller recommends putting T after Cycle Stop Valve and running 1 line through any filters and to the house and running 2nd line directly to the 3 Hydrants.

Will untreated Manganese cause problems for the 3 hydrants?

Thanks
Ken