Messages

1

Pumps, Wells, Tanks, Controls / Re: Electronic Pressure Switch Blinking Pr

« on: June 25, 2012, 12:56:17 PM »

Thank you Cary. I did go back to my old pressure switch and the pump is running just fine. We have good pressure that I haven't seen for years!!
I do not believe that I had the M1 and M2 switched. The old pressure switch is a Square D and as soon as I wired it it brought the pump to life. I had the wires marked so I think I had them installed in the same manner on the EPS15/99. I had popped the breakers once on the the EPS when I had the Line In and the Cable to the pump to the wrong leads at the start. .

Regards,

Mark

2

Pumps, Wells, Tanks, Controls / Electronic Pressure Switch Blinking Pr

« on: June 24, 2012, 12:26:54 AM »

Hello,

Just completed installation of a model PK1AEPS pside-kick. After powering up the EPS15/99 the display of "Pr" blinks about every 5 seconds but will not kick on the submersible well pump. I can't find any explanation of the error. What can be done to correct the issue? I have my old pressure switch if I need to temporarily mount it but would like to avoid making the switch out. When the EPS arrived one of the brass mounting hex head screws was loose and rattling around though I find it unlikely that it caused the problem.

Regards,

Mark