1
Pumps, Wells, Tanks, Controls / Re: First CSV installation
« on: July 26, 2012, 08:46:50 PM »
I checked out the pk1a kit instructions. Do you sell the stainless steel pieces separately? I already have the CSV and the pressure tank.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Pumps, Wells, Tanks, Controls / Re: First CSV installation
« on: July 26, 2012, 01:20:18 PM »
No, I did not receive any plugs in the box. I will check out the pk1a in more detail tonight. Thank you!
3
Pumps, Wells, Tanks, Controls / First CSV installation
« on: July 26, 2012, 12:05:48 PM »
I recently purchased a CSV1A to install in my residence and have a few questions.
What are the two 1/2" and one 3/4" holes typically used for?
Since the CSV1A has two 1/2" and one 3/4" holes, what is best to use to plug them? Since it is stainless and I am concerned putting in a different metal, are there stainless plug and if so, where is the cheapest place to get them? On the same note, I would be willing to use the 1/2" holes for the pressure switch and gauge; however, the ones I have found are 1/4". Do 1/2" ones exist? Should I consider using a coupler? For the 3/4", it would be ideal to use this with the pressure tank; however, I believe the pressure tank has a 1" inlet.
Thank you
What are the two 1/2" and one 3/4" holes typically used for?
Since the CSV1A has two 1/2" and one 3/4" holes, what is best to use to plug them? Since it is stainless and I am concerned putting in a different metal, are there stainless plug and if so, where is the cheapest place to get them? On the same note, I would be willing to use the 1/2" holes for the pressure switch and gauge; however, the ones I have found are 1/4". Do 1/2" ones exist? Should I consider using a coupler? For the 3/4", it would be ideal to use this with the pressure tank; however, I believe the pressure tank has a 1" inlet.
Thank you
Pages: [1]