Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - FoxRedLab

Pages: [1]
1
Valve Tech / Re: Plumbing Pside-Kick into PVC System
« on: September 20, 2014, 08:54:46 AM »
Thanks! I hadn't thought about using an adaptor with 1" male threads and a 1-1/4" slip. That approach might be the best for the money, and I can see that the friction loss would be minimal.

A more general question: when installing threaded PVC fittings into/onto threaded steel, should any type of Teflon tape, pipe dope, or sealer be used? I know the answer for metal-to-metal and PVC-to-PVC, but can't find definitive advice for PVC-to-metal.

2
Valve Tech / Plumbing Pside-Kick into PVC System
« on: September 20, 2014, 12:48:58 AM »
I just purchased a Pside-Kick to use with a pump in my drinking water storage tank. I intend to use 1-1/4" Schedule 40 PVC. Because the CSV1A has 1-1/4" male pipe threads on both ends of it, it seems that I will need to use a coupling on each end. However, it is not recommended to use a female-threaded PVC coupling on metal pipe threads because of the superior strength of the metal and the thermal expansion differential between the two materials. That does seem to be how it was done on the YouTube video, though, so I'm puzzled. Would I be better off using stainless steel female to female couplings (~$10 each!), and then installing a PVC adaptor with male threads on one end and a socket connection on the other? (It seems to be OK to install PVC male threads into metal female threads.)

Also, the clamps in the wall-mounting system for the CSV1A are sized to fit 1-1/4" pipe. Therefore, they can't be clamped around a coupling, and they won't fit between the coupling and the valve body. It seems, then, that they would have to be installed so that they clamp around pipe that comes out of whatever adaptor I use. As far as I can tell in the YouTube video, the clamps fit around the white pieces attached to both ends of the valve. I assume that the latter are PVC couplings that are female-threaded on the valve side with a glue-up socket on the other side. The outside diameter of such fittings is too large for the clamps I have to fit around them!

Am I the first person to have encountered this issue? I scanned the FAQs and could not find a similar issue.

Pages: [1]