1
Open Loop Geothermal Heat Pump / Re: Placement of cycle stop valve
« on: September 13, 2016, 05:34:30 PM »
Good diagram, thanks. I am going to show this to my driller.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Open Loop Geothermal Heat Pump / Placement of cycle stop valve
« on: September 13, 2016, 03:47:17 PM »
I am installing a deep well, 1 hp pump delivering 15gpm, and have a 3 ton open loop geothermal heat pump being installed. House is 3 bedroom. Heat pump will run virtually always in first stage, requiring about 5gpm. The driller is suggesting a cycle stop valve at the top of the well, which would actually be under ground. I would have to house it in some sort of box, I guess. The house is about 200 ft from the well, using 1-1/4 pipe. 34 gal pressure tank at the house. Is this the best location for the cycle stop valve, and where can I view a line diagram of an install like this?
Pages: [1]