Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - jstadick

Pages: [1]
Pumps, Wells, Tanks, Controls / Re: Wiring Deluxe Control Box
« on: April 29, 2021, 07:28:34 PM »
Yeah, the more I thought about it, I also came to the conclusion that you would only need one side of the switch as the control box is doing the real work.  As always, thanks for the quick and accurate help!  I can't wait to get all this completed and working. 

Thanks Cary.  I'll adjust a little and then dial in with shower test once it's all hooked up.

Pumps, Wells, Tanks, Controls / Wiring Deluxe Control Box
« on: April 29, 2021, 11:26:46 AM »
Need to double check the wiring of my Grundfos deluxe control box.  Their (Grundfos's) instructions aren't that clear.  See attached image.  In the Grundfos instructions it only show two wires going to the pressure switch (which didn't seem right).  Your instructions seem to make more sense, but wanted to double check.  I should have three wires (not including ground) going from the control box to the pressure switch correct? 

Pumps, Wells, Tanks, Controls / How may turns on CSV adjustment bolt
« on: April 28, 2021, 10:03:24 AM »
I've just about got all my parts together for my new pump and the CSV1 install.  When I ordered it, I had it preset to 55psi.  I want to increase that to 60 psi.  I've adjusted the pressure switch (was preset to 45/65) to 50/70 based on the assumption that one full turn on the pressure switch is about 2-3 psi.  I know I can adjust the CSV1 after install, but was wonders is there a rule of thumb for the CSV bolt turns as relates to PSI increase.  I'm just trying to get everything set as close as possible before turning on everything and I could find my answer with the search.

Applications / Re: Correct Product Selection/Setup
« on: November 17, 2020, 08:24:08 PM »
Well (pun intended), I hope to add my own glowing review.  Just ordered it!

Applications / Correct Product Selection/Setup
« on: November 17, 2020, 09:13:57 AM »
Hi, looking for so help in determining if/which of your products could help us.  We just purchased a home with an existing 1600sf ish ranch with 2 baths connected to the existing well.  The well is 115ft deep, has a yield of 35 GPM with a 10 GPM submersible pump with pressure tank and 30/50 pressure switch.  We plan to build a new home about 65ft from the well and supply water to the new home from the existing well (see attached diagram).  We had a company come out and checkout the well and they suggested that we just add an additional pressure tank at the new house and all should be good.  I'm concerned about having enough pressure and reducing cycling on the pump.  Would/which of you products would be beneficial for us?  Thanks for any help/advise! 


Pages: [1]