1
Valve Tech / Re: cleaning rust out of the CSV
« on: July 03, 2016, 05:08:07 PM »
awesome thanks.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Valve Tech / Re: cleaning rust out of the CSV
« on: June 30, 2016, 09:27:15 AM »
Thanks for the reply Cary. I have your CSV1A valves.
Additional info...I have installed a prefilter now but the valve doesn't seem to like it as it will pressure up to 60 psi and then stop and chatter down to 50 some time 40. So I pulled the filter from the filter housing and the valve seems OK. What micro size of filter should I use. This one is a 50 micron.
Scott
Additional info...I have installed a prefilter now but the valve doesn't seem to like it as it will pressure up to 60 psi and then stop and chatter down to 50 some time 40. So I pulled the filter from the filter housing and the valve seems OK. What micro size of filter should I use. This one is a 50 micron.
Scott
3
Valve Tech / cleaning rust out of the CSV
« on: June 28, 2016, 08:01:58 PM »
Hi,
Im a newbie so please bare with me. I installed your valve as im on a dug well up here in Canada. I bought 2 to have a backup.....luckily. Resently my pump would not hold pressure and eventually ran constantly. I remove the valve and it was full of sediment and rust. I figure it was holding the valve from seating. I replace the csv and everything returning to normally. I intend installing a preefilter to protect the valve from this happening again. Looking into the valve you can clearly see rust coating the valve internally. Can you us say CLR to clean the valve and bring it back to service as my back up.
Scott.
Awesome product
Im a newbie so please bare with me. I installed your valve as im on a dug well up here in Canada. I bought 2 to have a backup.....luckily. Resently my pump would not hold pressure and eventually ran constantly. I remove the valve and it was full of sediment and rust. I figure it was holding the valve from seating. I replace the csv and everything returning to normally. I intend installing a preefilter to protect the valve from this happening again. Looking into the valve you can clearly see rust coating the valve internally. Can you us say CLR to clean the valve and bring it back to service as my back up.
Scott.
Awesome product
Pages: [1]